Click on the following transition to find out more information

Cones Rectangle to Rectangle Rectangle to Round Pipe Intersections

 

Thicknes

Thickness of metal that will be used in the Elbow.

Diameter

Choose Inside or Outside depending on the information given about the Elbow (example, if dimension is given from outside to outside then select outside diameter and input correct diameter).

Throat Radius

From center point to the Elbow.

Center Radius

From center point to center of Elbow diameter.

Number of points

Number of points that each section of the elbow will be broken up into ( the more points the smoother the elbow, but more work to plot out.)

 
Elbow Layout
The Elbow layout shown above represents a full section. The end section of the elbow will be half of the above view cutting on the vertical line A. The numbers generated by the Elbow program will be in the coordinate form. To obtain the bottom half of the layout associate a negative value with the y axis (example point zero is at (0,1) and (0,-1) ).

 

Design
Layout